Tacoma single dating site

Rated 4.34/5 based on 501 customer reviews

There are at least two additional finish related mold seams - one at the top of the finish which encircles either the bore or sometimes the outside of the upper lip portion of the finish (sometimes of these seams are present) and a horizontal seam immediately below the finish which circles the extreme upper neck (called a "neck ring parting line").

(Mold seam thickness and how high it protrudes [height] is of only moderate use in telling a machine-made bottle from a mouth-blown bottle, though if a bottle fragment has a hair fine mold seam, it is highly likely to be from a machine-made bottle.) 3.Feature #2 (mold seam diameter) is not as strongly diagnostic as the primary indicators as mouth-blown bottles sometimes can have very fine mold seams.Feature #7 describes a couple glass related features that are quite consistent in machine-made bottles, but not diagnostic, i.e., mouth-blown bottles may sometimes have few/no bubbles in the glass and even thickness.General Machine-made Diagnostic Features: Machine-made bottles will exhibit most or all of the diagnostic characteristics explained and illustrated below.(This summary is largely an amalgam of Toulouse 1969b; Miller & Sullivan 1981; Jones & Sullivan 1989; Boow 1991; Cable 1999; Miller & Mc Nichol 2002; Miller & Morin 2004; empirical observations.) It should be noted that features #1, #3, #4, #5, and #6 are primary indicators of machine-made manufacture.

Leave a Reply